Temporary Spoofer

The spoofer is temporary and remains active only for the current Windows session. After restarting your PC, all hardware identifiers return to their original values automatically. You must run the spoofer again before launching any supported game after every reboot.

Before You Start

Complete all required preparation steps before attempting to inject the spoofer.

→Restore PointCreate a restore point before making any changes →Install RuntimesInstall Visual C++, WebView2, Rivatuner and DirectX →Disable AntivirusRemove third-party antivirus and disable Windows Defender →System RequirementsCheck that your Windows version and hardware are supported →Disable ProtectionsDisable virtualization and other security requirements →Exploit ProtectionsReset Windows Exploit Protection settings

Restore Point

Create a Windows restore point before making any system modifications.

Install Runtimes

Install all required runtimes including Visual C++, WebView2, DirectX and Rivatuner.

Disable Antivirus

Disable Windows Defender and remove any third-party antivirus software before injection.

System Requirements

Verify your Windows version and hardware meet all supported requirements.

Disable Protections

Disable virtualization, Kernel DMA Protection and any required Windows security features.

Exploit Protections

Set all Windows Exploit Protection settings back to their default values.

Requirements

• Your system must meet the System Requirements.
• If you were banned, reinstall Windows and run the spoofer before launching the game again.
• The spoofer must be injected before opening the supported game.

Setup

1. Run the Loader

1. Open the loader as administrator.
2. Enter your activation key.
3. Configure the desired spoofer options.
4. Click Inject and wait for confirmation.
5. Close the loader after a successful injection.

2. Launch the Game

Once injection is complete, launch your game normally. The spoofed identifiers remain active until Windows is restarted.

Static Seed

The Static Seed option allows the spoofer to generate the same spoofed hardware values every session. This is useful when a consistent hardware identity is required.

If a ban occurs while using Static Seed:

1. Open the loader.
2. Navigate to the spoofer settings.
3. Click Random Static Seed.
4. Inject again and continue normally.

Generate a new seed after every ban. Reusing a previously flagged seed may continue to associate the account with prior hardware traces.